Filter
Top Products
© 1999 Directed Electronics, Inc.Vista, CA 19
N430 9/99
4. Transmit While holding the Valet
®
/program button, use the arm/disarm button of the
transmitter, to toggle between the one and two chirp settings.The one-chirp
settings are the factory defaults.
5.
Release The button can now be released.
For example, to program the arming mode from active to passive, press and release the Valet/program button once.
Then press and hold it. The siren will chirp once, indicating that the setting can now be changed. While holding the
Valet/program button, press the arm/disarm button on the transmitter. The siren will chirp twice to indicate that
passive arming has been programmed. If this is the desired setting, release the Valet/program button.If this is not the
desired setting, continue to hold the Valet/program button and press the arm/disarm button on the transmitter again.
The siren will chirp once indicating that active arming has been programmed. Once the desired setting has been
selected, release the Valet/program button.
You can advance from step to step by pressing and releasing the Valet/program button the number of times neces-
sary to get from the step you just programmed to the step you wish to access. If you just programmed the
arm/disarm chirps to off and you want to program passive locks, release the Valet/program button, press and
release it twice to step from feature two to feature four.Then press it once more and hold it. The unit will chirp four
times to confirm that you have accessed feature number four.
The Learn Routine
™
will be exited if:
• The ignition is turned on.
• The door is closed.
• The Valet
®
button is pressed too many times.
• More than 15 seconds elapses between steps.
The siren will emit a long chirp when Learn Routine
™
is exited.