Filter
Top Products
© 1999 Directed Electronics, Inc.Vista, CA 17
N430 9/99
TWO-VEHICLE OPERATION WITH SINGLE TRANSMITTER
You can get two-vehicle operation with the transmitters that come with the system. However, you cannot use all the
auxiliary channels of the system (or all the auxiliary channels of the other system), unless using a 485T 4-button
transmitter.
Here's what to do:
1. Using Learn Routine™, program Button I into system # 1 as the arm/disarm button. Do this with all four
remotes.
2. Do the same with system # 2, except program Button II of all four remotes as the arm/disarm button.
If using DEI
®
485T four-button remotes,
all auxiliary channels are available on both vehicles. Before program-
ming, make a list of all channels on each vehicle, and decide which button(s) should control which channel.
For example, if you wanted the top two buttons to control vehicle # 1 and the bottom two buttons to control vehicle
# 2, here is how each system would be programmed:
Vehicle # 1: Button I = arm/disarm.
Button II = trunk release/Silent Mode
™
.
Button I+II = channel two. (Instant)
Vehicle # 2: Button III = arm/disarm.
Button IV = trunk/release/Silent Mode
™
.
Button III+IV = channel two. (Instant)