Filter
Top Products
16 © 1999 Directed Electronics, Inc.Vista, CA
N430 9/99
TRANSMITTER/RECEIVER LEARN ROUTINE™
In order to enter Learn Routine
™
the Valet
®
/Program button must be plugged into the blue port. There is a basic
sequence to remember whenever programming this unit: Door, Key, Choose, Transmit and Release.
1. Door Open a door. Either the H1/5 green or the H1/7 violet door trigger wire must be
connected for the control unit to “see” an open door.
2. Key Turn the ignition on to the run position. The H1/9 yellow switched ignition input must
be connected.
3. Choose Within 15 seconds, press and release the momentary button to select the channel
you wish to program:
Press and Release
To Program
One time Arm/disarm/panic
Two times Channel two output
(Silent Mode
™
/Remote Valet
®
)
Three times Channel two output (instant)
NOTE: When programming a transmitter button to step three, the assigned button will provide an instant
output on the red/white wire.
Once you have selected the step, press the button once more and hold it.The unit will chirp one, two or three
times depending on the channel selected. Do not release the momentary button.
4.Transmit While holding the momentary button, press the button on the transmitter that you
would like to control the selected receiver channel. One chirp will confirm that the
code has been learned.
5. Release Once the code is learned, the button can be released.
You can step from one step to another by releasing the Valet
®
/program button and tapping it to advance steps and
then holding it. For instance:You have programmed channel one and you want to program channel two. Release the
Valet
®
/program button. Press it one time and release it to advance from step one to step two. Now, press and hold
the button down and the unit will chirp twice. As before, do not release it.
If you want to program channel two (instant) after programming channel one, release the momentary button press
it twice and release it to advance to step three.Then press it once more and hold it. The siren will chirp three times
to confirm it is ready to receive the code from the transmitter.
Learn Routine
™
will be exited if:
• Ignition is turned off
• Door is closed
• Program button is pressed too many times
• More than 15 seconds elapses between steps
One long chirp indicates that Learn Routine
™
has been exited