Filter
Top Products
26
© 2004 directed electronics, inc.
ppoowweerr ssaavveerr mmooddee
Your system will automatically enter Power Saver Mode while armed or
in Valet
®
Mode, after a period of time in which no operation has been
performed. This lowers the current draw to the vehicle’s battery. Power
Saver Mode takes over under the following conditions:
➤ Power Saver when the system is armed: After the system has been
armed for 24 hours, the in-vehicle LED will flash at half its normal
rate, decreasing the system's current draw.
➤ Power Saver in Valet
®
Mode: When the system enters Valet
®
Mode
the in-vehicle LED illuminates steadily. If the vehicle is not used
(ignition is not turned on) for a period of one hour while the
system is in Valet
®
Mode, the LED will shut off. If the system
remains in Valet
®
Mode, the LED will come back on the next time
the ignition is turned on and then back off.
pprrooggrraammmmiinngg ooppttiioonnss
Programming options control what your system does during normal op-
eration, and require few or no additional parts. However, some may
require additional installation labor.
The following is a list of the program settings, with the factory settings
in Bold: