Filter
Top Products
19
© 2004 directed electronics, inc.
To enter or exit Valet
®
Mode using the 2-way remote:
1. Open any vehicle door.
2. Press .
3. Press .
4. Press again.
The in-vehicle status LED will light solidly if you are entering Valet
®
Mode, and it will go out if you are exiting Valet
®
Mode. The remote
responds with the normal arm/disarm notifications with each remote
button press.
nuisance prevention
®
circuitry
Your system has Directed’s Nuisance Prevention
®
Circuitry (NPC
®
). It
prevents annoying repetitive trigger sequences due to faulty door pin
switches or environmental conditions such as thunder, jackhammers,
airport noise, etc.
Example
If the alarm triggers three times within a 60-minute period and each
time the same sensor or switch triggers the alarm, NPC
®
will interpret
those triggers as false alarms. After the third trigger, NPC
®
ignores, or by-
passes, that sensor or switch (along with any other sensors or switches
sharing the same zone) for 60 minutes.
If the bypassed sensor tries to trigger the system while it is being
bypassed, the 60-minute bypass period will start over. This ensures that
a sensor that continually triggers will remain bypassed.
Doors are covered by NPC
®
differently; if the alarm is triggered by an
open door for three full cycles, the doors will be bypassed until the
trigger ceases.
➜