Filter
Top Products
13
© 2004 directed electronics, inc.
multi-level security arming
Multi-Level Security Arming allows you to select which of the system's
inputs or sensors will be active and which will be bypassed when the
system is armed. (See Table of Zones section of this guide.) Pressing
(only in Standard Configuration) again within five seconds of
arming the system will activate the Multi-Level Security feature. Each
time is pressed again, a different security level is selected. The
different security levels are selected as follows:
➤ Press once: The siren chirps once. The system is armed.
➤ Press a second time within five seconds: The siren chirps
twice followed by a long chirp. Zone 2 is now bypassed.
➤ Press a third time within five seconds: The siren chirps three
times followed by a long chirp. Zone 4 is now bypassed.
➤ Press a fourth time within five seconds: The siren chirps four
times followed by a long chirp. Zones 2 and 4 are now bypassed.
➤ Press a fifth time within five seconds: The siren chirps five
times followed by a long chirp. All input zones, except the igni-
tion, are now bypassed.
After each press of the to reach the next level of security, the
remote will emit normal arm notification (1 beep and 3 flashes of the
Orange LED). For easiest operation in reaching each level of security,
press immediately after each notification.
NOTE: Multi-Level Security Arming only applies to a single arm-
ing cycle. Once the system is disarmed and then re-armed, all
the zones will be active again.
➜