Filter
Top Products
9
© 2004 directed electronics, inc.
out of range notification
If a command is issued from the remote, but the remote is beyond the
range of the vehicle to receive the command, the remote responds with
2 sets of 3 quick beeps and the Green LED will flash 6-times.
pprrooggrraammmmiinngg 22--wwaayy rreemmoottee
To enter programming mode
Press and hold all four remote control buttons simultaneously until one
long beep is heard. Programming mode is now entered.
Beeps On/Off
Press to select beeps On/Off. One beep is notification beeps On,
Two beeps is notification beeps Off. The notification beeps are
programmed On from the factory and can be programmed Off if they
are not desired. When programmed Off the remote will only flash the
LEDs as notification of a command page or an alarm page.
Remote battery low notification
Press to select low battery notification On/Off. One beep is low
battery notification On. Two beeps is low battery notification Off. The
Low battery Beeps are programmed On from the factory and can be
programmed Off if they are not desired. When programmed Off the
remote will not give any notification that the battery charge level in
the remote is low.
➜