Filter
Top Products
Deepstor
User Instructions
ISSUE 1 User Instruction
AUGUST 2003 Page 15
UNLOADING THE SYSTEM
Step 1 The forklift truck approaches the rack squarely and aligns itself centrally
with the desired lane.
Step 2 Slow down and stop the truck at the entrance to the lane. Reduce any tilt
on the mast and raise the forks to the required storage level ensuring the
truck is still central between the pallet rails.
Step 3 Drive slowly into the lane up to the desired pallet location. Stop the truck
just clear of the load and adjust the forks if required before entering the
pallet.
Step 4 Lift the pallet clear of the pallet rails, and slowly reverse the truck out of the
storage lane ensuring the way is clear.
Step 5 When clear of the rack lower the forks to the correct travelling position
before moving off.
Follow the above retrieval sequence to avoid potential access beneath stored pallets.