Filter
Top Products
52
© 2006 Directed Electronics
Testing the system
Once steps 1-7 have been completed, the operation of the system
can be tested.
Ensure that the two 30-amp fuses are in the relay harness PINK
wire fuse holders. Make sure that the vehicle is in park with the
emergency brake on and the hood closed. Press 2 times on
the remote to initiate the remote start function. The parking
lights should flash to confirm the remote start command has been
received, The accessories and ignition should turn on followed by
the starter cranking and the vehicle engine running (this may take
a moment to initiate). Pressing 2 times again on the remote
will shut the engine off. (See Programming System settings
section for 1 press remote start operation)
This completes the testing, if all functions do not work correctly
check your wiring against the manual and verify all connections.
If you still experience problems contact Directed Technical
Support at 1-800-477-1382.