Filter
Top Products
MAN 650067:F
6
MESSAGE DISPLAY
Since the VFD 3X systems use a shared message center for speed and tach messages
both Switch 1 and 2 are used to cycle through the various messages. Use Switch 1 to select
different message screens (Mileage, Performance, Tach Bar). Use Switch 2 to change between
different readings within the same screen (Trip A, Trip B, Service or km/h, Hours, Hi RPM). If
any BIM modules are connected the information will be shown at the bottom of the Tach Bar
screen. Some typical display screens for the message display are:
Mileage screen with the GEAR menu turned ON. (requires optional GSS-2000)
000000 A 000.0 000000 B 000.0 000000 S 0000
P R N O D 2 1 P R N D 2 1 P R N D 2 1
Mileage screen with the GEAR menu shut OFF.
ODOMETR 000000 ODOMETR 000000 ODOMETR 000000
TRIP A 000.0 TRIP B 000.0 SERVIC 0000
Tach Bar screen
1 2 3 4 5 6 7 8 1 2 3 4 5 6 7 8 1 2 3 4 5 6 7 8
Km/h 00 Hours 000.0 Hi RPM 0000
Performance Screen
00 0.0 0.0 00 0.0 00
HI 0-60 1/4 HI 0-60 1/4
Wait, Brake, 4x4, and Engine indicators use reverse image letters in the message display corners when active.
W B x4 E
Available readings:
odometer mileage (0-999,999)
trip A odometer mileage (0-9999.9)
trip B odometer mileage (0-9999.9)
miles since last service (0-9,999, or ---- when past due) (when enabled)
0-60 mph time in seconds (0-25.5) (when enabled)
high speed recall (0-255) (when enabled)
¼ mile time in seconds (0-25.5) (when enabled)
end of ¼ mile speed (0-255) (when enabled)
kph conversion (or mph conversion if kph selected as primary unit)
high rpm recall (0-18,000)
hours system has been on with tach signal (0-999.9)
bar tach readout on message display (0-8)
gear shift position indicator (with purchase of optional GSS-2000)
Future BIM module messages will display in the message display as well
NOTE: In normal operation you have to use switch 1 (SW1) to reset trip meters, service
counter, hour meter, high RPM, and the various performance timers. A press and hold
will zero the current reading, if it can be reset.
Odometer miles
Trip A miles
Gear position with overdrive
Trip B miles
Service miles (when enabled)
High speed recall
0-60 time
¼ mile time
Tach Bar (rpm x1000)
Km/h conversion
Hour meter
High RPM recall
Odometer miles
Trip A miles
Trip B miles
Service miles
¼ mile speed
Gear position without overdrive