Filter
Top Products
MAN 650067:F
15
DISPLAY RIBBON CABLE
This is where the grey cable from the display system plugs into the control box.
To connect the ribbon cable from the display system to the control box;
• First open the two locking tabs on either side of the blue RIBBON CABLE connector.
• Next align the red stripe in the ribbon cable with the “STRIPE” text on the control box.
• Finally press the ribbon cable into the connector, press firmly to seat the connector.
• The two locking tabs should “snap” into place securing the connector.
***Do NOT force the connector, if it is not inserting easily, check alignment of the red
stripe on the ribbon cable with the indicator on the control box.
Locking tabs closed Locking tabs OPEN
Align stripe Ribbon cable connected
RED STRIPE
LOCKS
CLOSED