Clifford concept 30 Automobile Alarm User Manual


 
Adding new remote controls
For other drivers in your family or if you wish to control Concept systems on your
other cars with the same remote control, you can buy additional remote controls
from any Authorized Clifford Dealer (or call our 24-hour Customer Service
Department at 800-824-3208) and program them into the system yourself. Each
Concept 30 will respond to as many as four 12-channel remote controls. To add a
new remote control to the system, use the procedures noted in the User-selectable
features section on pages 16–17.
How to erase the codes of lost or stolen remote controls
If one of your remote controls is ever lost or stolen, you can push its digital codes
out of the system memory to make sure that the missing remote control can never be
used to disarm your system. To do so, just re-program your current remote
control(s) as noted in the
User-selectable features
section on pages 16–17 for a total
of four times (e.g., if you have one remote control remaining, program it four times;
if you have two remote controls, program each twice).
Example
To change the AutoArming feature from its factory setting of on to off, you
would do the following:
Turn the ignition key to the ON position.
Enter your valet code, then immediately tap and release the
momentary side of the PlainView switch 4 times (you will hear a
single chirp upon the 4th press).
Wait 3 seconds. The system will sound one more chirp to confirm that
the AutoArming setting has been changed.
Turn the ignition off (you’ll hear 3 chirps to confirm exit of program
mode).
That’s all there is to it!
18