Clifford concept 30 Automobile Alarm User Manual


 
User-selectable features
Your Concept 30 vehicle security system allows you to set many of its features to
your own personal preferences. We have made the programming procedures very
simple: to make a change, you just press the PlainView switch a few times.
The system comes from the factory with all of its features pre-programmed as noted in
the table below and on page 17. To change any of the settings, use the procedure
noted. To restore the feature to its factory setting, just repeat the procedure:
1. Select the feature you wish to program from the table below and on the following
page. Note the number of momentary (spring-loaded) presses.
2. Turn your vehicle’s ignition switch to its “ON” position.
3. Enter your valet code.
4. When the LED turns on, immediately tap and release the momentary side of the
switch the number of times indicated in the third column of the programming
table for the feature you selected (after the first three taps, you will hear a single
chirp confirmation each time you tap the momentary side).
a. If noted, perform the “secondary action.”
5. Return the switch to its center position. You will hear 1 chirp and the LED will
turn off. Turn the ignition off and you will hear 3 chirps to indicate that you have
exited programming mode.
6. Repeat steps 1-5 for any other features you wish to program.
Programming table for user-selectable features
Feature
Factory
setting
# of
momentary
taps
Secondary
action
Program
completion
confirmation
Result
AutoArming
ON
4
1 chirp 3
seconds after
last step
Change state from
ON to OFF or vice-versa
AutoArm
& Lock
OFF
5
1 chirp 3
seconds after
last step
Change state from
ON to OFF or vice-versa
Arm/Disarm
Chirp
Confirmation
ON
6
1 chirp 3
seconds after
last step
Change state from
ON to OFF or vice-versa
QuietChirps
OFF
7
1 chirp 3
seconds after
last step
Change state from
ON to OFF or vice-versa
Valet Code
See How to set your own secret valet code on page 11.
AutoLock/
AutoUnLock
ON
9
1 chirp 3
seconds after
last step
Change state from
ON to OFF or vice-versa
16