Filter
Top Products
TO ACTIVATE
THE PANIC
FEATURE . . . . . . . . . .
Press button 1 for 3 seconds. The lights will flash repeatedly
and the Insignia™ siren will blare for 30 or 60 seconds
(user-selectable), or until you press button I again to turn it off.
TO SILENTLY
ARM OR DISARM
THE SYSTEM . . . . . . .
Press button 3 (channel 3). Your Concept 30 system will arm
or disarm with all the indications noted on the previous page
except for the chirp acknowledgments.
TO REMOTELY
TURN ON THE
HEADLIGHTS
— OR —
REMOTELY CLOSE
THE WINDOWS
WHILE THE SYSTEM
IS
ARMED . . . . . . . . .
Button 2 (channel 2) controls an electronic interlock that
allows you to separately command two different options with
the same channel: one when the system is armed and another
when it is disarmed. For instance, if your Concept 30 was so
wired, pressing button 2 while the alarm is armed will either
turn on the headlights for any duration you wish between 1
second and 2.5 minutes (see the Built-In Timer feature in the
User-selectable features section on pages 16–17) OR will
fully close all the power windows and sunroof on various
Jaguar, BMW and Volkswagen vehicles.
TO REMOTELY
OPEN THE TRUNK . . .
As noted above, button 2 (channel 2) can control yet another
option when the system is disarmed. The most obvious one is
the remote trunk release. If you have this option installed,
pressing button 2 while the alarm is disarmed will remotely
open the trunk.
TO ACTIVATE
OTHER OPTIONS
REGARDLESS OF
ALARM STATE. . . . . . .
Button 4 (channel 4) and channels 5–12 (see
How to use your
keychain remote control on page 6) can activate other
accessories such as the Clifford IntelliStart remote engine
starter, remote memory seat activation or SmartWindows II
remote window roll-down and venting, as well as single
Programmable Receiver(s) that lets you command your
electric garage door and/or gate opener(s), etc. You may also
assign any of these channels to control Clifford systems on
your other vehicle(s).
AntiScan™
Thieves can disarm some other brands of car alarms with a “scanner” that rapidly
transmits one remote control code after another. Clifford’s AntiScan will detect any
scanner and block the codes it generates.
8