Clifford concept 30 Automobile Alarm User Manual


 
To enable valet mode
1. Turn the ignition switch to its “ON” position or start the engine.
2. Enter your secret valet code, then return the switch to its center position.
3. You now have 3 seconds to press the latched position (valet mode). Once you
have entered valet mode, the system’s LED will glow continually for on-going
visual confirmation of valet mode.
Keyless entry in valet mode: Even if valet mode is enabled, you can still
remotely control the convenience features. For instance, simply press button 1
(channel 1) as if you were disarming. The doors will unlock (as indicated by
one flash of the parking lights) and the interior lights will illuminate. Press
button 1 (channel 1) again and the doors will lock (as indicated by two flashes
of the parking lights). You can also use the remote control’s other channels to
activate options such as a remote trunk release or remote engine starting.
To exit valet mode
1. Turn the ignition switch to its “ON” position or start the engine.
2. Flick the switch back to its center position. The LED will turn off to confirm that
the system is now in its normal operating mode.
How to set your own secret valet code
Since all Concept 30 systems have the same factory-set code, it is highly advisable
that you set your own valet code. You may choose any 1-, 2-, or 3-digit code that
does not have any zeros. You can also change your valet code whenever you want.
1. Write down the 1-to-3 digit code you wish to use (remember, no zeros in the
code).
2. Turn your vehicle’s ignition switch to its “ON” position.
3. Enter your current valet code (if this is the first time you are setting a new code,
enter the factory-set code of “2” by tapping the momentary [spring-loaded] side
of the switch twice, then pressing the latched side).
4. When the LED turns on, immediately tap and release the momentary side of the
switch 8 times (after the first three taps, you will hear a single chirp confirmation
each time you tap the momentary side — in this case for a total of 5 chirps).
5. Immediately after the 5th chirp, press the latched side of the switch, then enter
each digit of your new code. After each digit of your code is entered by pressing
the latched side, you will hear the same number of chirps as the digit you just
entered. When done, return the switch to its center position. You will hear 1
chirp and the LED will turn off. Turn the ignition off and you will hear 3 chirps
to indicate that you have exited programming mode.
6. VERY IMPORTANT: You must immediately test your new valet code to ensure
that you entered it correctly. To do so, turn the ignition on, enter your new code,
then press the latched side. The LED should be illuminated. NOTE: If the LED
does not illuminate, your new code was entered incorrectly. The system has
automatically reverted to the previous valet code.
11