Filter
Top Products
31
© 2006 directed electronics
pin programming
A PIN code can have one to four digits; each digit can be from 0-9.
Programming Procedure
1. Enter the feature location in the installer programming grid.
2. Immediately press and release of the PlainView 2 Valet button.
3. Select each digit by pressing 1-9 times, and then press
to enter the number into the system. To enter a zero,
press only.
4. Wait for two siren chirps after a five second pause or five
seconds after the last digit has been entered if using less
than four digit code number.
5. Turn off the ignition; the siren will chirp three times.
6. The programming mode is now exited.
To program a PIN code of 1032:
1. Press and release once and once. You will
hear one chirp.
3. Press and release once. You will not hear a chirp
after programming a zero.
5. Press and release three times, and then press
once. You will hear three chirps.
6. Press and release two times, and then press
once. You will hear two chirps.
nnoottee::
A PIN code cannot begin with a zero.