Filter
Top Products
© 2004 directed electronics, inc.
disarming without a remote
This feature allows you to disarm the system without the remote should
it be lost, damaged, or disabled. In order to disarm without a remote,
you must have the vehicle’s ignition key, know where the PlainView 2
Valet
®
button is located, and have the PIN code. Be sure to check with
the installer for the location of the PlainView 2 Valet
®
button. Please
refer to the Disarm/Valet
®
Mode section of this guide for instructions to
enter the pin code.
remote siren silencing
This system offers remote siren silencing. Remote siren silencing is a fea-
ture that makes it possible to silence and reset the system when it is
triggering without disarming the system. If the system is triggered and
the siren has been sounding, press on the remote to stop the
trigger and return the unit to the armed state. The system will not dis-
arm, but rather reset. This prevents you from disabling the system
should you wish to silence it without visually checking the vehicle. After
resetting the system, press again to disarm the system.
remote chirp muting
To temporarily turn off the arm or disarm chirps, use remote chirp mut-
ing. Simply press on the remote, and the confirmation chirp(s)
will be eliminated for that one operation only. The parking lights will
flash to confirm the arm/disarm command. If you want the arm/disarm
chirps turned off permanently, please refer to the User-Selectable
Features section of this guide.