Filter
Top Products
20
z
Power Saver when the system is armed: After the system has
been armed for 48 hours, the LED will flash at half its nor-
mal rate, decreasing the system's current draw.
z
Power Saver in Valet
®
Mode: When the system enters Valet
®
Mode the LED illuminates steadily. If the vehicle is not used
(ignition is not turned on) for a period of one hour while the
system is in Valet
®
Mode, the LED will shut off. If the system
remains in Valet
®
Mode, the LED will come back on the next
time the ignition is turned on and then back off.
programming options
Programming options control what your system does during normal
operation, and require few or no additional parts. However, some may
require additional installation labor.
Following is a list of the program settings, with the factory settings in bold:
z
Active arming (only with the remote) or passive arming (au-
tomatic arming 30-seconds after the last door is closed).
z
Arming/disarming confirmation siren chirps on or off.
z
Auto-Lock on/off/rpm.
ON: The doors will lock three seconds after the ignition is
turned on unless a door is open.
RPM: The doors will lock when the engine speed increases.
z
Auto-Unlock on/off: With this feature on, the doors will
unlock when the ignition is turned off.
z
Passive door locking (with passive arming) or active door
locking (only when arming with the remote). Passive locking