Filter
Top Products
Black plate (131,1)
Model "Z51-D" EDITED: 2010/ 7/ 23
SIC3613
3. Using both hands, simultaneously push and
hold both the HomeLink
®
button you want to
program and the hand-held transmitter
button.
DO NOTrelease the buttons until step 4 has
been completed.
4. Hold down both buttons until the indicator
light on HomeLink
®
flashes, changing from a
“slow blink” to a “rapid blink”. This could
take up to 90 seconds. When the indicator
light blinks rapidly, both buttons may be
released. The rapidly flashing light indicates
successful programming. To activate the
garage door or other programmed device,
push and hold the programmed HomeLink
®
button - releasing when the device begins to
activate.
5. If the indicator light on HomeLink
®
blinks
rapidly for two seconds and then turns solid,
HomeLink
®
has picked up a “rolling code”
garage door opener signal. You will need to
proceed with the next steps to train Home-
Link
®
, completing the programming may
require a ladder and another person for
convenience.
6. Push and release th e program button
located on the garage door opener’s motor
to activate the “training mode”. This button is
usually located near the antenna wire that
hangs down from the motor. If the wire
originates from under a light lens, you will
need to remove the lens to access the
training button.
NOTE:
Once you have pushed and released
the training button on the garage door
opener’s motor and the “training light”
is lit, you have 30 seconds in which to
perform step 7. For convenience, use
the help of a second person to assist
when performing this step.
7. Quickly (within 30 seconds of pushing and
releasing the garage door opener training
button) and firmly push and release the
HomeLink
®
button you’ve just programmed.
Push and release the HomeLink
®
button up
to three times to complete the training.
8. Your HomeLink
®
button should now be
programmed. To program th e remaining
HomeLink
®
buttons for additional door or
gate openers, follow steps 2 through 8 only.
NOTE:
Do not repeat step 1 unless you want to
“clear” all previously programmed Home-
Link
®
buttons.
If you have any questions or are having difficulty
programming your HomeLink
®
buttons, please
refer to the HomeLink
®
web site at: www.
homelink.com or call 1-800-355-3515.
PROGRAMMING HomeLink
®
FOR CA-
NADIAN CUSTOMERS
Prior to 1992, D.O.C. regulations required
hand-held transmitters to stop transmitting after
2 seconds. To program your hand-held trans-
mitter to HomeLink
®
, continue to push and hold
the HomeLink
®
button (note steps 2 through 4
under “Programming HomeLink
®
”) while you
push and re-push (“cycle”) your hand-held
transmitter every 2 seconds until the indicator
light flashes rapidly (indicating successful pro-
gramming).
Instruments and controls 2-59