Clarion Z51-D Automobile User Manual


 
Black plate (126,1)
Model "Z51-D" EDITED: 2010/ 7/ 23
operation, push either of the OPEN
*
1
, CLOSE
*
2
or UP
*
5
of the switch.
Tilting moonroof
To tilt up the moonroof, push the moonroof
switch to the up position
*
5
.
To tilt down the moonroof, push the switch to the
up position
*
5
or push the CLOSE side
*
2
of
the switch.
When the moonroof is tilted up, push the
CLOSE side of the moonroof switch to the
second detent
*
4
. The moonroof will tilt down
and the sunshades will close.
Auto revers e function
WARNING
There are some small distances imme-
diately before the closed position which
cannot be detected. Make sure that all
passengers have their hands, etc., in-
side the vehicle before closing the
moonroof.
If the control unit detects something caught in
the moonroof and sunshades when they are
closing, the moonroof will be immediately
opened.
The auto reverse function can be activated when
the moonroof and sunshades are closed by
automatic operation when the ignition switch is
in the ON position or for about 45 seconds after
the ignition switch is pushed to the OFF
position.
If the moonroof and sunshades cannot be
closed automatically when the auto reverse
function activates due to a malfunction, push
and hold the CLOSE side
*
2
of the moonroof
switch.
Depending on the environment or driving
conditions, the auto reverse function may
be activated if an impact or load similar to
something being caught in the moonroof
occurs.
If the moonroof does not operate
If the moonroof does not operate properly,
perform the following procedure to initialize the
moonroof operation system.
1. If the moonroof is open, close it fully by
pushing the CLOSE side
*
2
of the moon-
roof switch.
2. Push and hold the CLOSE side
*
2
of the
moonroof switch.
3. Release the moonro of swit ch after t he
moonroof or sunshade moves slightly to
the closed position.
4. Push and hold the CLOSE side
*
2
of the
moonroof switch for 10 seconds.
5. The moonroof and sunshades will fully open
and then close.
6. Check if the moonroof switch operates
normally.
If the moonroof does not operate properly after
perfo rming the procedure above, have your
vehicle checked by a NISSAN dealer.
2-54 Instruments and controls