Filter
Top Products
3
50061011 Chevy Impala SS
A Division of KW automotive North America, Inc
INSTALLATION INTRODUCTION
1. REMOVING THE FENDER, DOORS FROM THE A-PILLAR AND DISCONNECTING THE
WIRE HARNESS @ THE DOOR JAM
2. REMOVING THE EXISTING DOOR HINGES FROM THE DOORS; TOP AND BOTTOM.
3. MODIFYING THE INTERNAL FENDER AREAS FOR THE HINGE CLEARANCE.
4. MODIFYING THE ELECTRICAL HARNESS.
5. INSTALLING THE GROUND PLATE TO THE A-PILLAR AND THE SWING ARM TO THE
DOOR.
6. HANGING AND ALIGNING THE VEHICLE DOORS.
7. INSTALLING THE FENDER AND CHECKING FOR CLEARANCE.
8. REMOVE FENDER AND ROUTE THE WIRING.
9. RE-INSTALL FENDER AND CHECK FOR CLEARANCE.
10. JOB COMPLETE!