Filter
Top Products
17
50061011 Chevy Impala SS
A Division of KW automotive North America, Inc
STEP 5 MODIFYING THE CHASSIS WIRING HARNESS
IMPORTANT NOTE: Prior to beginning extending the wiring harness from the A-pillar,
each individual wire needs to be cut one at a time. Each wire that is cut, has to be staggered
(See 5g) from the previous cut wire. By doing this, you will eliminate, when wrapping all the
wires, one large taped ball.
5a. If the wiring harness comes equipped with an insulation cover, this will need to be
removed.
STEPS 5b thru 5f are for REFERENCE ONLY (using white wire as reference)
5b. Isolate a single wire (Photo 9). Start the first cut on the white wire approximately 3”
from the door frame.
5c. Cut the wire sheath (insulation) (coming from door frame) back approximately
1/4” (Photo 10). Twist the end tight.
5d. Cut the wire sheath (insulation) (from kit supplied white wire) back approximately 1/4”.
Twist the end tight.
5e. Using the kit supplied heat shrink connector ends, insert the wire ends into the connec-
tor, one from each end (Photo 11).
5f. Using the heat gun, shrink wrap the connector ends to securely mate with the wire
ends (Photo 12).
PHOTO 9
PHOTO 10 PHOTO 11 PHOTO 12