Filter
Top Products
18
50061011 Chevy Impala SS
A Division of KW automotive North America, Inc
STEP 5 MODIFYING THE CHASSIS WIRING HARNESS –cont’d-
5g. VERY IMPORTANT:
5h. Remember to stagger the cuts for each individual wire. This will eliminate having a
large wrap and will allow for minimal size and maximum flexibility.
5i. In the photo below an (INCORRECT) version is shown. By cutting it this way, wrapping
the wire at the end, will create a large ball in the middle of the newly extended wire har-
ness. Wire harness flexibility would be minimal.
5j. By staggering the cuts, (CORRECT), you eliminate creating a large taped ball, thus
making it easier to install back in the chassis. Wire harness would have minimal size
and maximum flexibility.
5k. On this particular install, a kit supplied cover plate is used on the door itself (Photo 13).
This cover plate is not mounted with any hardware, but instead is held in place by the
LSD Swing Arm.
5m. Once both cover plates have been fed onto the new extension wire harness, you are
able to attach the wire connector end of the A-Pillar (Photo 14).
INCORRECT CUTS CORRECT CUTS
PHOTO 13
PHOTO 14