Filter
Top Products
26
50061011 Chevy Impala SS
A Division of KW automotive North America, Inc
STEP 10 ROUTING THE WIRE HARNESS
10a. Pivot the door carefully up and make sure there is sufficient clearance on the fender, A-
pillar and hood. If necessary, adjust the Ground plate or the LSD swing arm
again.
10b. Lay the wire harness on and attach it to the marked points shown (Photo 26). Secure
the wire harness with the kit supplied cable ties.
PHOTO 26
Exact locations for
clips may vary for the
amount of wiring on
vehicle
Allow for movement
in this area, check
with fender and door
ZIP TIE/TIE WRAPS ZIP TIE/TIE WRAPS ZIP TIE/TIE WRAPS