Filter
Top Products
; (Parking Lamps): Turns on the parking lamps
together with the following:
.
Instrument Panel Lights
.
Taillamps
.
License Plate Lamps
2 (Headlamps): Turns on the headlamps together with
the following lamps listed below.
.
Parking Lamps
.
Instrument Panel Lights
.
Taillamps
.
License Plate Lamps
If the headlamps are turned on while the vehicle is on,
the headlamps turn off automatically 10 minutes after
the ignition is turned off. If the headlamps are turned on
while the vehicle is off, the headlamps will continue to
stay on. To prevent the battery from being drained, turn
the control to the
9 position.
A warning chime sounds if the driver door is opened
while the ignition switch is off and the headlamps
are on.
To change the headlamps from low beam to high beam,
push the turn signal/multifunction lever toward the
instrument panel.
Headlamps on Reminder
If a door is open, a reminder chime sounds when the
headlamps or parking lamps are manually turned on
and the key is out of the ignition. To turn off the chime,
turn the headlamp switch to off or auto and then back
on, or close and re‐open the door. In the auto mode,
the headlamps turn off once the ignition is in LOCK/OFF
or may remain on until the headlamp delay ends,
if enabled in the Driver Information Center (DIC).
See “Exit Lighting” under DIC Vehicle Customization
on
page 4‑53
.
Daytime Running Lamps (DRL)
Daytime Running Lamps (DRL) can make it easier for
others to see the front of your vehicle during the day.
Fully functional daytime running lamps are required on
all vehicles first sold in Canada.
The DRL system comes on in daylight when the
following conditions are met:
.
The ignition is on.
.
The exterior lamps control is in the AUTO position.
.
The shift lever is not in P (Park).
.
The light sensor determines it is daytime.
When the DRL are on, the taillamps, sidemarker,
instrument panel and other lamps will not be on.
4-10