Filter
Top Products
The horn may chirp when Q is pressed again within
five seconds. See DIC Vehicle Customization
on
page 4‑53
for additional information.
K (Unlock): Press to unlock the driver door. If K is
pressed again within five seconds, all remaining doors
unlock.
The interior lamps come on and stay on for 20 seconds
or until the ignition is turned on. If enabled through the
DIC, the parking lamps flash twice to indicate unlocking
has occurred. See DIC Vehicle Customization
on
page 4‑53
for additional information.
j (Cargo Door): Press to unlock only the cargo
doors.
/ (Remote Vehicle Start): For vehicles with this
feature, press
Q and then press and hold / within
five seconds to start the engine from outside the vehicle
using the RKE transmitter. See Remote Vehicle Start
on page 3‑7
for additional information.
L (Vehicle Locator/Panic Alarm): Press and release
to locate the vehicle. The turn signal lamps flash and
the horn sounds three times.
Press and hold
L for more than two seconds to
activate the panic alarm. The turn signal lamps flash
and the horn sounds repeatedly for 30 seconds. The
alarm turns off when the ignition is moved to ON/RUN
or
L is pressed again. The ignition must be in LOCK/
OFF for the panic alarm to work.
Programming Transmitters
to the Vehicle
Only RKE transmitters programmed to the vehicle will
work. If a transmitter is lost or stolen, a replacement can
be purchased and programmed through your dealer/
retailer. When the replacement transmitter is
programmed to the vehicle, all remaining transmitters
must also be programmed. Any lost or stolen
transmitters no longer work once the new transmitter is
programmed. Each vehicle can have up to four
transmitters programmed to it. See “Relearn Remote
Key” under DIC Operation and Displays
on page 4‑37
for instructions on how to match RKE transmitters to
your vehicle.
3-5