Filter
Top Products
Black plate (28,1)
Cadillac ATS Owner Manual - 2013 - crc - 6/5/12
7-28 Infotainment System
To hear all of the numbers
recognized by the system, say
“Verify” at any time.
1. Press
g. The system responds
“Ready,” followed by a tone.
2. Say “Digit Dial.”
3. Say each digit, one at a time.
After each digit is entered, the
system repeats back the digit it
heard followed by a tone. After
the last digit has been entered,
say “Dial.”
Once connected, the person called
will be heard through the audio
speakers.
Using the “Re-dial” Command
1. Press
g. The system responds
“Ready,” followed by a tone.
2. After the tone, say “Re-dial.” The
system dials the last number
called from the connected cell
phone.
Once connected, the person called
will be heard through the audio
speakers.
Receiving a Call
When an incoming call is received,
the audio system mutes and a ring
tone is heard in the vehicle.
.
Press g to answer the call.
.
Press c to ignore a call.
Call Waiting
Call waiting must be supported on
the cell phone and enabled by the
wireless service carrier.
.
Press g to answer an incoming
call when another call is active.
The original call is placed
on hold.
.
Press g again to return to the
original call.
.
To ignore the incoming call, no
action is required.
.
Press c to disconnect the
current call and switch to the call
on hold.
Three-Way Calling
Three-way calling must be
supported on the cell phone and
enabled by the wireless service
carrier.
1. While on a call, press
g.
2. Say “Three-way call.”
3. Use the dial or call command to
dial the number of the third party
to be called.
4. Once the call is connected,
press
g to link all callers
together.
Ending a Call
Press c to end a call.