Filter
Top Products
18
3. Using the UP/DOWN buttons, scroll to highlight each character and press OK/SHOT. To delete
characters, scroll to “DELETE” and press OK/SHOT. When finished, scroll to highlight “SAVE” and
press OK/SHOT.
4. Next, select MAP GPS POINTS and press OK/SHOT (Fig. 16). Select the hole (Fig. 17), then the
default name for the point (Fig. 18) and press OK/SHOT.
5. If editing an existing point, select its name from the list, then press
OK/SHOT while standing at the point to register its new location.
When creating a new custom point select CSTM 1 (CSTM 2, etc)
and press OK/SHOT, You can then select ABBREVIATIONS (Fig. 19)
and pick from the list (CREEK, SAND, HZRD, etc.), or give it your
own USER DEFINED name. Next, make sure you are standing at the
point, and press OK/SHOT to register it. You can also just accept the
default name (CSTM 1) and go directly to REGISTER POINT.
Fig. 16 Fig. 17 Fig. 18
Fig. 19