Filter
Top Products
26
KEEP THIS MANUAL IN YOUR
GLOVEBOX TO USE AS A REFERENCE.
CLEARING THE E-PROM MEMORY
Take the BLACK wire with the green tag and attach it to a chassis ground
(shock or microwave sensor input) white plug with the override switch. Then
cycle the ignition key from off to run six times within five seconds. The
YELLOW WITH BLACK STRIPE ignition wire must be hooked up. Finally, unplug
the 11-pin harness, wait one minute then plug it back in. Press any button
on the remote transmitter.
HOW TO USE YOUR
REMOTE TRANSMITTER CONT.
25
KEEP THIS MANUAL IN YOUR
GLOVEBOX TO USE AS A REFERENCE.
HOW TO USE YOUR
REMOTE TRANSMITTER CONT.
DUAL LOCK/UNLOCK PULSE
To program the Dual Lock/Unlock Pulse, press Button #3 for ten (10) seconds.
The system will chirp once. Press Button #4 within two (2) seconds and the
system will chirp once again to signify that the dual unlock pulse is programmed.
The above steps must be repeated to program dual pulse lock (2 chirps), both
dual pulse lock and unlock (3 chirps), then no dual pulse functions (4 chirps).
PROGRAMMING A NEW TRANISMITTER (up to 4 remotes allowed)
Press and hold Button #1 for ten (10) seconds while the system is disarmed.
The system will flash the arm flashes and will chirp once after the ten (10)
second period. Immediately press a button on the new and the parking lights
will flash twice.
HORN/SIREN FUNCTIONALITY
To program the Horn/Siren Functionality, press and hold Button #4 for ten
(10) seconds. The system will chirp once. Press Button #3 within two (2)
seconds and the system will chirp once again signifying that the horn output
is selected. To program the siren output, follow the above steps, and two (2)
chirps will be heard after pressing Button #3, signifying that the siren output
is selected.
DOOR PIN POLARITY PROGRAMMING
Press and hold Button #4 for approximate ten seconds or until the unit chirps
once. Release Button #4 and press and release Button #1. If the unit chirps
once the module is programmed for a (+) positive door pin input. If the unit
chirps twice then it is programmed for a (-) negative. If you need to go back
and program for one or the other, you must start from the beginning.
CLEARING THE E-PROM MEMORY
Take the BLACK wire with the green tag and attach it to a chassis ground
(shock or microwave sensor input) white plug with the override switch. Then
cycle the ignition key from off to run six times within five seconds. The
YELLOW WITH BLACK STRIPE ignition wire must be hooked up. Finally, unplug
the 11-pin harness, wait one minute then plug it back in. Press any button
on the remote transmitter.