Filter
Top Products
22
HOW TO USE YOUR
REMOTE TRANSMITTER
BUTTON #2
OPTION #2
BUTTON #4
BUTTON #1
ARM/DISARM
BUTTON #3
OPTION #3
KEYLESS ENTRY
FUNCTIONS
LOCKING DOORS
Press transmitter Button #1
to lock the doors. The
parking lights will flash once
and the horn or siren will
sound acknowledging the
unit received the signal.
UNLOCKING DOORS
Pressing transmitter Button #1 again will unlock the doors. The parking lights
will flash twice and then stay on for approximately 30 seconds and the horn
or siren will sound twice acknowledging the unit received the signal. NOTE:
If dome light feature is installed, the dome light will come on and stay on for
30 seconds.
LOCKING AND UNLOCKING WITH IGNITION SWITCH
See keyless entry programming options. NOTE: If your vehicle already has
this option, (Factory Installed) do not activate.
FULL TIME SILENT KEYLSS ENTRY
This will eliminate the horn or siren from sounding when locking or unlocking
your doors (See Silent Arming & Disarming in Alarm Programming Options).
ARMING
Press Button #1 to arm the system. The siren will chirp once, the lights will
flash once, the power door locks will lock and the LED will flash slowly to
indicate that the system is now armed. The engine starter is also disabled.
DISARMING
Press Button #1 while the system is armed and the system will be disarmed.
The siren will chirp twice, the lights will flash twice (and stay on for 30 seconds)
showing that the system is disarmed. If you hear three (3) siren chirps and
see three (3) light flashed when disarming, the vehicle was violated while you
were away. The LED will flash the zone violation (see page 23). When disarming,
the dome light will turn on for 30 seconds.
SILENT ARMING/DISARMING
Press and hold Button #1 to arm, but continue to hold the button. After three
(3) seconds, the system will perform all arming functions as described above.
except there will be no chirps (for this arming period only).
21
CONNECTING DOOR LOCKS
CONT.
One Wire Door Lock System (Example is for Chrysler)
BLUE/BLACK Lock Output
BLUE/WHITE
Not Used
RED/BLACK
GREEN/BLACK
Unlock Output
GREEN/WHITE
Not Used
DOOR LOCK PLUG
+12V Constant
FUSE
NOTE: Connect the RED WITH BLACK STRIPE
wire to +12V constant power.
This is a one (1)
wire door locking
system and will
require two (2)
resistors to lock
and unlock the
doors. Locate the
WHITE/DK
GREEN wire in
the drivers kick
panel. This wire
controls the door
locks. Add the
resistors as
stated in the
diagram. Wire
the unit in as a
Type A system.
620 OHM resistor to
unlock, must be 5%
tolerance.
2700 OHM resistor
to lock, must be 5%
tolerance.
Type C Reverse Polarity (5-pin harness)
NOTE: You will need to cut factory wiring to make an end
to end connection, see Making Connections on pages 2-4.
POWER
DOOR
LOCK
MOTOR
UNLOCK
LOCK
BLUE/BLACK Lock
BLUE/WHITE
Lock
RED/BLACK
GREEN/BLACK
Unlock
GREEN/WHITE
Unlock
MODULE
+12V Constant
FUSE
NOTE: Connect the RED WITH BLACK STRIPE
wire to +12V constant power.
*
BULLDOG