Filter
Top Products
bühler
1500 Bale Carrier
24
3. Taillight Assembly
Refer to Carrier Bundled Assembly drawing:
Remove and inspect all required hardware from parts box.
Mount lights using fasteners supplied
Connect the taillight wiring harnesses to their appropriate connections.
Connect main lighting plug to tractor.
Test by verifying correct lamps illuminate when signalling and braking.
.
4. Bale Retainer Weldment
Remove the hardware from parts box and transfer on to bale retainer weldment.
Place the weldment on the matching bolt holes in the position shown in Carrier
Bundled Assembly drawing. Torque the provided hardware to the specifications
listed on the bolt chart.
5. Fixed Loading Arm
CAUTION
Stay clear of the arm when testing a finished assembly.
Ensure during assembly to keep your entire body out from underneath parts that are
being attached to the main frame.
Remove lift arm pivot pins that are installed
on the carrier.
Thoroughly lubricate all pins involved in the
assembly with SAE multi purpose grease.
Align arm to pivots with open end of arm
facing forward and reinstall pins with
hardware provided and torque to
specifications called for in the bolt chart.
Remove the lift cylinder pin from the arm.
36.0"
FIXED LIFT ARM
ATTACHMENT ASSEMBLY
LAYOUT
Align the lift cylinder rod and reinstall the pin.
Adjust the outside bale fork to be positioned at the end of the lift arm and the
inner bale fork about 36” (91 cm) from the end.
Recheck all hardware so that every bolted connection on the lift arm is torqued
according to the specifications of the bolt chart.
Approach the bale and inspect to ensure the spacing of the forks is accurate.
For first operation, cycle the lift arm slowly with a bale and inspect just before
lifting bale from ground.
Finish the cycle and observe how the bale transits from the forks to the carrier
beam. If transition is smooth with minimum bale binding, assembly is completed.
If not, adjust the forks to a different location and try until loading is smooth.