Filter
Top Products
bühler
1500 Bale Carrier
15
7. Unloading
DANGER
Make sure area is clear before unloading. Failure to do so
could result in serious injury or death.
NOTE:
Do not run pusher all the way to the end, the resulting shock load may cause
damage to chain and drive.
Extend tilt cylinder to raise carrier beam by engaging the tractor’s extension
hydraulics.
Depress and hold the PUSHER BACK switch to push the bales off the carrier
beam.
Once the rear bale has been pushed off the carrier, slowly drive forward while
pushing the bales back (unloading) to keep all bale ends in contact.
When amber reflector on inside of the carrier
beam becomes visible stop the pusher. The
reflector is approximately 26” (66cm) from the
end of the beam.
Release PUSHER BACK and slowly drive
forward to unload the last bale. Retract the tilt
cylinder to lower the beam and begin the next
loading cycle.
AMBER REFLECTOR
LOCATION