Filter
Top Products
14
Parameter 45 & 55 Alarm 1 & 2 Pulse off Time
This parameter defines the number of seconds the output should be disabled during the off
phase of an active pulsing alarms output.
Parameter 46 & 56 Alarm 1 & 2 Pulse Count
This setting determines how many pulses are output when the alarm is activated and is
configured in pulse output style. When 0 is entered, the unit will be set for continuous pulses while
the alarm is active.
Parameter 47 & 57 Alarm 1 & 2 Lower Limit
This setting defines either the lower limit or lower end of a range for the alarm region. Alarm limits
are set in display units without regard to decimal point or colon position. In Rate and Counter
Modes, a limit of 123 could represent a display value of 123, 12.3, 1.23, or 0.123. When in Time
Mode, a limit of 123 would represent 1:23 on the display.
Parameter 48 & 58 Alarm 1 & 2 Upper Limit
This setting defines either the upper limit or upper end of a range for the alarm region. Alarm
limits are set in display units without regard to decimal point or colon position. In Rate and
Counter Modes, a limit of 123 could represent a display value of 123, 12.3, 1.23, or 0.123. When
in Time Mode, a limit of 123 would represent 1:23 on the display.
Parameter 95 Factory Settings Command
When set to a value of 5, the unit will be reset to factory settings. This can also be achieved by
applying power to the unit with both the Enter and Down buttons depressed. The programming
jumper must be in the "On" position for this method to function.
Parameter 98 Save to User Settings Area Command
When set to a value of 5, the unit will store all adjustable parameters to the user settings area.
The user settings area is intended to be a location where a user can store settings specific to
their application. A user can easily refresh their custom settings. Another common use for this
area is testing and initial setup. The user can store known-good settings here and easily
experiment without the fear of losing the optimal configuration.
Parameter 99 Restore from User Settings Area Command
When set to a value of 1, the unit will restore the all adjustable parameters from the user settings
area. See parameter 98 for additional information.