Filter
Top Products
CT-3200 Installation Guide P. 9
Button Ι for Option 1,
Button ΙΙ for Option 2,
Buttons Ι & ΙΙ for Option 3.
Table 3
Programming Options
MODE 1 (* indicates default setting)
FUNCTION 1 – Ignition-controlled Door Locks
OPTION 1* Ignition-controlled Door Locks DISABLED
OPTION 2 Ignition-controlled Door Locks ENABLED
OPTION 3 Ignition-controlled Door Locks DISABLED
FUNCTION 2 – Secure Lock
OPTION 1* Secure Lock DISABLED
OPTION 2 Secure Lock ENABLE
OPTION 3 Secure Lock DISABLED (½ second disarm pulse)
FUNCTION 3 – Passive / Active Arming of the Starter Kill
OPTION 1* Starter Kill PASSIVE (1-minute timeout.)
OPTION 2 Starter Kill ACTIVE
OPTION 3 Starter Kill PASSIVE (3-minute timeout.)
FUNCTION 4 – Lock Pulse Duration
OPTION 1* 7/10-second LOCK / UNLOCK pulses
OPTION 2 4-second LOCK / UNLOCK pulses
OPTION 3 7/10-second LOCK pulse and two ¼-second UNLOCK pulses
FUNCTION 5 – Flashing LED
OPTION 1* ENABLED (without starter kill Æ will flash only when ignition is OFF)
OPTION 2 DISABLED
OPTION 3 ENABLED (with starter kill Æ will flash when the starter kill engages.
This option should be selected ONLY if the starter kill is installed.)
MODE 2 (* indicates default setting)
FUNCTION 1 – Engine Run Time
OPTION 1 4-minute Run Time in Gas Mode / 9-minute in Diesel Mode.
OPTION 2* 15-minute Run Time in Gas Mode / 20-minute in Diesel Mode.
OPTION 3 25-minute Run Time in Gas Mode / 30-minute in Diesel Mode.
FUNCTION 2 – Idle Mode
OPTION 1 Idle Mode DISABLED
OPTION 2* Idle Mode ENABLED
OPTION 3 Idle Mode DISABLED
FUNCTION 3 – Engine Type – Gas or Diesel
OPTION 1 DIESEL Engine Mode (in Cold Weather Mode Run time 20 min).
OPTION 2* GASOLINE Engine Mode
OPTION 3 DIESEL Engine Mode
FUNCTION 4 – AUX 1 programming
OPTION 1 N/A
OPTION 2* Panic mode (by pressing and holding the Ι key until horn honks)
OPTION 3 Horn confirmation when pressing Ι button
Auto Tach Programming Procedure
NOTE: If no tach has been programmed and the ΙΙ button is pressed, there will be no
start attempt and the vehicle will give 5 flashes. If another tach programming is required,
simply repeat the auto tach programming procedures. The module stores the tach
setting, being autotach or multi-speed tach, until the module is reset. Only if the
module is reset will a new tach signal need to be re-programmed.