Filter
Top Products
P. 2 Installation Guide CT-3200
Introduction
This guidebook contains all information pertinent to the installation. Most (if not all) features are
grouped in the user guidebook and therefore, should you need information on a feature, you should
refer to the user guidebook.
Included in the Package
Before beginning the installation, please review the installation guide – especially the wiring
diagram and the programming options.
It is very important that you familiarize yourself with the programming and operation of the system,
even if you have already installed such a system in the past. There are many great new features
that may be overlooked if you do not read the manual; this would prevent you from maximizing the
potential of the module.
Prior to the installation, make sure that all the hardware components required to install the system
are in the box.
The following is a list of components included in the kit:
1 – control unit
1 – 2-button transmitter
1 – r-1 interconnect cable
1 – r-1 receiver
1 – hood pin-switch
1 – 6 pin main ignition harness
1 – 5 pin secondary harness
1 – 12 pin accessories harness
1 – warning label, user guide
The plug-in valet and the 2-volt plug-in
LED are not included with this model
INDUSTRY CANADA USER NOTICE:
Operation is subject to the following two conditions: (1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired
operation of the device. To reduce potential radio interference to other users, the antenna type and
its gain should be so chosen that the equivalent isotropically radiated power (EIRP) is not more
than that required for successful communication".
FCC USER NOTICE:
The manufacturer is not responsible for any radio or TV interference caused by unauthorized modi-
fications to this equipment. Such modifications could void the user’s authority to operate the
equipment.
Installation Tools:
Here is a list of basic tools and supplies you will need to test and install safely.
• Digital Multi Meter (DMM), Computer safe logic probe, Fused jumper wire, Neon 'trouble' light
that is carpet safe, Fender protector, Carpet protector
• Soldering Iron, solder, electrical tape, wire tie straps, split loom, diodes, resistors, relays
• Wire cutters, Wire strippers, Wire crimpers, Needle Nose Pliers
• Sharp knife, Panel poppers, Various Screw drivers
• Socket set, Wrench set, Drill with Drill Bits, Coat hanger (for fishing wires through the fire
wall),
Before You Get Started…
♦ on vehicles with a manual transmission,
always ensure that all doors will get the unit out
of ready mode. Switch the wire used so that it is
triggered by all doors.
♦ make sure that the parking brake and door
switch contacts work properly.
♦ when working on a vehicle, always leave a
window open.
♦ never leave the keys in the car. Leave them
on a workbench with a window rolled down.
♦ remove courtesy light fuse, if possible, to
prevent battery drain.
♦ the programming assistance button (a.k.a.
PAB.)
The PAB is mounted on the side of the unit.
This push button mimics the hood-pin switch in