Filter
Top Products
CT-3200 Installation Guide P. 7
starter motor while the glow-plug indicator light is still on.
The module will engage the starter motor as soon as the glow-plug light
(+) goes out.
• Minimum waiting time is 3 seconds.
• Maximum waiting time is 25 seconds (approx).
If no glow-plug wire is found on the vehicle, the glow-plug input on the
module may be “timed out”. The module will power up the ignition and
glow-plug circuits and simply wait for the time-out before starting:
Connecting the glow-plug input wire of the module to ignition will hold the
ignition on for the maximum waiting time (25 sec., recommended).
Keeping the glow-plug input wire of the module unconnected will hold the
ignition on
for the minimum waiting time (3 sec., not recommended in
very cold environments). Connect the glow-plug wire to the ignition wire
only after tach has been programmed (i.e.: connecting the glow-plug wire
is one of the very last steps in the installation process.
Flashing the Hood Pin
What is flashing the Hood Pin?
It is a procedure that makes the module go into the programming centre. Once the module is in
the programming centre, the installer has no more than 20 seconds to get into one of the sub-
menus. Failure to do so will result in the module exiting the programming centre and the
installer will have to flash the hood pin once more.
Remember: You can use the Programming Assistance Button instead of the hood pin
any time the hood is up.
The Installer … The Module …
1. Press and hold the hood pin for 4 seconds.
2. Let go of the hood pin. Parking lights “ON”
3. While the parking lights are on, press down the hood
pin once more.
4. Release the hood pin again. “ON” for 20 seconds
5. You now have 20 seconds to select one of the sub-
menus.
Once inside the programming centre, the installer has a selection of many different sub-menus.
Once you are in the programming centre, you have the option of the following menus:
a) Transmitter Programming ………………….. p.8
b) Programming Options …………………..… p.9
c) Honk Horn Timing* (*if available) ………..… N/A
d) Tach Programming …………………..……… p.9
Remember: you have up to 20 seconds, once the parking lights are on solid, to select a sub-
menu, failure to do so will result in the module exiting the programming centre and the installer
will have to flash the hood pin once more.