Autostart CT-3200 Remote Starter User Manual


 
P. 12 Installation Guide CT-3200
seconds after shutdown, Secure Lock will re-lock all Doors once more (arming the system again).
Please note that most OEM systems will not rearm the Alarm while the Engine is running, but will
lock the Doors.
Passive or Active Arming Starter Kill
tive (will not arm automatically) or passive (will arm
on
Ι (or
ation can be programmed to give 7/10-sec.
LOCK and UNLOCK pulses (by
Engine Run Time
ule can be programmed to keep the Engine running for 4, 15 (default), or 25
mmed, this option allows the user to engage the remote starter to take over the
Resetting the Module (without the plug-in valet)
e, you can avoid resetting the
on:
The Starter Kill can be programmed to be ac
automatically). In Passive Mode, you can program it to arm automatically after 1 or 3 min.
To disarm the Starter Kill in Active or Passive Mode, the user must press and hold butt
enable Valet Mode). The Parking Lights will flash twice. If the Door Locks option was installed, this
will also unlock the Doors. To arm the Starter Kill in Active or Passive Mode, the user must press
and hold button
Ι. The Parking Lights will flash once. (If the Door Locks option was installed, this
will also lock the Doors). In Passive Mode, the system will automatically arm itself 1 or 3 minutes
after the Engine is shut down.
Lock Pulse Duration
The Door Lock pulse dur
default), 4-sec.
LOCK and UNLOCK pulses, or for a 7/10-sec. LOCK pulse and two 1/4 -second
UNLOCK pulses (used for double-pulse disarm/unlock systems).
In
GAS mode the Mod
minutes. In
DIESEL mode the Module can be set to 9, 20 (default) or 30 min.
Idle Mode
When progra
vehicle while it is already running. This option will keep the vehicle running for the pre-programmed
run time, or until it is shut down.
Resetting the Module is not a required process. Most of the tim
Module by fixing the issue directly at the root of the cause.
To reset the Module, without using the plug-in Valet butt
1. FLASH the hood pin switch.
2. In ten seconds or less, press the Brake Pedal six times.
3. The Parking Lights will flash 8 times confirming the Reset.
Table 6
On some vehicles, such as, BMW, and certain ns, etc., pressing the Brake pedal without
Resetting the Module (with the use of the plug-in valet)
e all Transmitter codes
Volkswage
the key in the Ignition
ON position, will not work and therefore you will need to hot wire the brake
Pedal–manually jumping 12Volts, with a fused test lead, at the Brake Pedal switch.
The system is equipped with a reset function that allows the installer to eras
and return all programmed Options to the factory default values.
To reset the Module:
1. FLASH the Hood pin switch.
2. Press the Valet Button (if the plug-in valet was installed) 6 times or more, until the
Parking Lights start to flash.
3. times confirming the Reset.
The Parking Lights will flash 8
Table 7