Filter
Top Products
The Programming Assistance
Button (a.k.a. PAB.)
The PAB is located on the side of the
module. This push button mimics the
hood-pin switch in order to avoid having
to get out of the vehicle and pressing
the hood-pin switch. The PAB will work
only when the hood is up.
Before Programming a Transmitter
The transmitter is not delivered pre-programmed: it must be programmed after the wiring of the
module is completed. The module has the ability to retain up to 4 different transmitter codes; if a
fifth transmitter is programmed, the code of the first transmitter will be erased from memory.
How to Program the Transmitter.
1. FLASH the hood pin switch.
Before the 20 seconds have passed, turn the ignition key to the IGNITION ON (RUN) position and
then to the OFF position.
2. Press and hold button Ι until the vehicle gives 5 flashes. The module has stored the
transmitter in its memory.
3. Close the hood, to exit.
Table 1
How to Enter Programming Options Mode
The system is equipped with two custom programming modes, allowing the installer to custom-fit
the system according to the requirements of each vehicle. When getting into the programming
option mode, the parking lights will flash once, twice depending on the option you have entered.
The unit will stay in programming mode until the hood pin-switch or the brake pedal is pressed
again; therefore take your time to make the proper selection. To return to the programming centre
(main menu), press on the brake pedal.
1. FLASH the hood pin switch.
Before the 20 seconds have passed,
2. Press and hold the brake pedal, then press one of the following buttons on the
transmitter:
Button Ι to enter mode 1;
Button ΙΙ to enter mode 2.
The parking lights will flash once or twice to confirm entry into a mode.
3. Release the brake pedal.
Table 2
The module can only be programmed function by function. After selecting a mode (1 or 2), you
will be taken to the first function of that mode. After entering an option selection for function 1, you
will be automatically taken to function 2, and so on; therefore, be ready to re-enter all option
selections for all functions of the mode you are accessing. You may not skip functions*.
*note: pressing the brakes at any given moment will save the selection(s) you have entered and
will return you to the programming center.
For each function, select one of the three options by pressing the corresponding button on
the transmitter:
P. 8 Installation Guide CT-3200