Filter
Top Products
User Guide P. 9
The engine will go on running until the user re-enters the vehicle or until the expiration of the
Engine Run Time
If your vehicle has a manual transmission, Idle Mode can be activated through the same routine
as that used for Ready Mode; at the last step, the button is pressed instead of the other
buttons:
1. Ensure that all the Doors are closed and that the Shifter is in the Neutral position.
2. With the Engine already running, apply the Parking Brake and release the Brake Pedal.
Make sure to release the brake pedal.
3. Within 20 sec. push , or on the Transmitter.
The parking lights will flash 3 times quickly and remain lit.
4. Remove the key: the Engine will go on running.
5. Exit the vehicle and close the Door.
6. Press the button until the system is armed (the doors will be locked if remote door
lock is installed).
If the pre-programmed run-time expires or if the user shuts down the engine by remote control, the
vehicle will get in Ready Mode.
Caution!!! Do not leave children or pets unattended in a vehicle standing in Idle Mode.
Valet Modes
Ignition Valet
This feature will allow you to remotely put your system into valet mode by using the ignition key
instead of the valet button as above. Ignition valet can be used without a valet button installed.
To put the system i n t o valet mode:
Insert the ignition key into the ignition switch. Within 10 sec., turn the key 5 times successively into
the IGNITION ON / RUN and OFF positions.
The parking lights will flash three times to indicate that the vehicle is now in valet mode. The L.E.D.
will come ON solid.
— The icon will appear on your LCD remote if you press LOCK or UNLOCK..
To take the system o u t o f valet mode:
Insert the ignition key into the ignition switch. Within 10 sec., turn the key 5 times successively into
the IGNITION ON / RUN and OFF positions.
The parking lights will flash twice to indicate that the vehicle is now out of valet mode. The L.E.D.
will go out.
— The icon will disappear from your LCD remote if you press LOCK or UNLOCK.
Note: With the Ignition valet activated, the remote starter and the alarm function will be disabled.
Remote Valet Mode
This feature will allow you to remotely put your system into valet mode by using the transmitter
instead of the valet button as above.
Getting into valet mode
• Hold the and buttons simultaneously for 3 second.
• The parking lights will flash 3 times.
The LED will remain on solid.
— The icon will appear on your LCD remote.
Getting out of valet mode
• Hold the and buttons simultaneously for 3 second.
• The parking lights will flash 2 times.