Filter
Top Products
User Guide P. 7
Button LCD Sounder
L --02 → Unlock button
(2
nd
car unlock)
ULOCK and Unlock icon 2 beeps
L --02 → Trunk button(2
nd
car trunk)
TRUNK text for 1s 1 beep
L --02 → Start button(2
nd
car start)
START text for 1s 1 beep
L --03 → Lock button
(Channel 1)
1 beep
L --03 → Unlock button
(Channel 2)
1 beep
L --03 → Trunk button
(Channel 3)
1 beep
L --03 → Start button
(Channel 4)
1 beep
Remote-Starting Your Vehicle
If your vehicle has an automatic transmission, simply press the START/STOP button to remote
start or stop your vehicle. Skip the next steps on to “Remote-starting”.
Warning: If you vehicle has an automatic transmission and the parking lights flash 15 times after
pressing the START/STOP button, the parking brake is connected to ground. It is imperative that
you see your installer and have him disconnect the wire.
Setting Your Vehicle Into Ready Mode
If your vehicle has a manual transmission you must read the following indications. In order to
start the vehicle by remote, the unit must first be set to Ready Mode. If the unit is not set to Ready
Mode, it cannot remote start the vehicle.
Please note that Ready Mode can be enabled by the remote or the handbrake, depending on
the option that was selected by your installer. Therefore, you must follow the appropriate
procedure between the two described below in order to set your vehicle into Ready Mode.
Once the system is set to Ready Mode, the vehicle can be remote started and stopped at any time.
The system will exit Ready Mode if a door, the hood or the trunk is opened, if the brake pedal is
pressed, if the parking brake is disengaged or if the ignition key is turned to the
IGNITION ON (RUN)
position.
To set the system to Ready Mode:
If Ready Mode is enabled by remote If Ready Mode is enabled by handbrake
1. Ensure that all the doors, hood and trunk are closed. Make sure that the gear selector is in the
neutral position.
2. With the engine already running, apply the
parking brake once and release the brake
pedal.
Make sure to release the brake pedal.
2. With the engine already running, apply the
parking brake twice and release the brake
pedal.
Make sure to release the brake pedal.
The parking lights will flash 3 times
quickly and remain lit.
Skip to step 4.
3. Within 20 sec. of engaging the parking
brake, press and hold LOCK, UNLOCK or
START/STOP on the transmitter.
The parking lights will flash 3 times
quickly and remain lit.
-
4. Remove the key: the engine will continue running.