Filter
Top Products
P. 14 User Guide
6. Press and hold either:
a. to lock the doors and shut down the engine after 60 sec.;
b. to unlock the doors and shut down the engine after 60 sec.;
c. to shut down the engine immediately, without affecting the doors
(this will by-pass Turbo Mode).
d. TO SET THE VEHICLE INTO IDLE MODE
Engine Run Time
If you have a gas engine, your remote starter can be programmed to run the engine for 3, 15, or
25 minutes (15 minutes by default). If you have a diesel engine, the remote starter can be
programmed to run the engine for 8, 20, or 30 minutes (20 minutes default).
How to Access to Runtime Status
(Indication purpose only)
Function By pressing Icon Gasoline Diesel
3 minutes 8 minutes
Engine runtime
15 minutes 20 minutes
25 minutes 30 minutes
Temperature Request (If ACC-Temp-100 installed)
The user can request the temperature in the vehicle if a Temperature Sensor Module (ACC-Temp-
100) is installed:
o Press the button for 1 second and release; you will hear a beep. L-01 will appear
on the screen.
o Immediately press the
button and hold it until the temperature is displayed on the
LCD screen.
Note: to change the temperature from Celsius to Fahrenheit, press + + simultaneously.
Horn Chirp Timing
The pulse duration can be configured by your installer (from 5 ms to 200 ms).
Flashing LED
The user may decide to turn on or off LED flashing at any moment. To do so, simultaneously press
and hold the
and buttons on the transmitter. There will be an initial beep. Keep holding
the buttons pressed until you hear another beep. At that point release the buttons. The parking
lights will flash once if the LED is turned on or three times if the LED is turned off.
There are three programmable options regarding the flashing LED:
i. The LED flashes once the starter kill is activated (passive or active arming) and will
turn itself off once the user turns the key to the
IGNITION ON position.
ii. The LED is totally disabled and will not flash –it will turn on solid, however, when in
valet mode.
iii. The LED will flash once the starter kill is activated but requires pressing the
button to turn itself off. Failure to press the
button will make the LED flash even
if the key is in the
IGNITION ON position.