Filter
Top Products
P. 12 User Guide
Remote Trunk Release
If your system was installed with the Remote Trunk Release option, you can open your trunk by
pressing the
button for 3 seconds on the remote transmitter. The OEM Alarm will remain
disarmed until the
button is pressed.
The Starter Kill and the Anti-grind Feature
With this added security feature, the system will prevent your vehicle from starting with the ignition
key when the starter kill is armed. If your remote starter was installed with the starter kill option,
one will not be able to start your vehicle with the key unless the system has been unlocked and
disarmed first, or put into valet mode.
Note: If the starter kill is installed, your vehicle will benefit from a protection against starter
motor damage that could occur after remote-starting the engine should the user, by force of
habit, turn the ignition key to the CRANK position.
Safe Start Mode
If this feature is enabled, the user must press the button 2 times within 3 seconds to remote-
start the vehicle. This will eliminate accidental remote starts, e.g. when children are playing with the
transmitter.
If swap start mode is selected, to remote-start your vehicle, press the
button and then the
button. The
AUX 2 output can be activated by pressing the button.
How to access Safe Start Mode
Function By pressing Icon Sound Instructions / description
Start on safe start
mode
x 2
+
Melody
Press
twice within 3 seconds.
Press for 1 sec-melody-then
press 1 sec.
Stop on safe start
mode
None Melody
Installer-programmable Valet Modes
Valet Mode Using the Valet Switch (if installed)
When your vehicle is in valet mode, the remote starter functionalities are disabled. If the vehicle
needs to be serviced, or if you park it indoors, the valet mode will prevent the engine from being
remote-started accidentally.
To put the system i n t o valet mode:
1. Turn the ignition key to the IGNITION ON (RUN) position.
2. Within 3 sec., press the valet button.
3. The parking lights will flash three times to indicate that the vehicle is now in valet mode. Turn the
ignition key to OFF position. The L.E.D. will come ON solid.
4. Press LOCK or UNLOCK and the icon will appear on your LCD remote.
To take the system o u t o f valet mode:
1. Turn the ignition key to the IGNITION ON (RUN) position.
2. Within 3 sec., press and release the valet button (the L.E.D. will come OUT).
3. The parking lights will flash twice to indicate that the vehicle is now out of valet mode.
The L.E.D. will go out.
— Press LOCK or UNLOCK and the icon will disappear from your LCD remote.
Note: Once valet mode using valet switch is activated, the remote starter and the alarm
function will be disabled.