Autostart AS-2450vTW-FM Remote Starter User Manual


 
P. 10 User Guide
The LED will turn off.
— The icon will disappear from your LCD remote.
Note: With the remote valet activated, the remote starter and the alarm function will be disabled.
Panic Mode
In an emergency situation, you can activate panic mode by pressing and holding the LOCK or
UNLOCK
button for 3 seconds. If the vehicle is under a remote start, the engine will shutdown
automatically before setting off the horn. You can stop the horn by pressing
(this will lock your
doors) or by pressing
(this will unlock your doors).
Furthermore, the panic mode can be stop by activating one of the following three (3) features:
a) Remote valet (pressing
and for 3 seconds)
b) Ignition valet (turning the key inside the ignition switch from off to on 5 times in a row)
c) Turn the key in ON position, then press the valet switch (if included).
Panic mode will automatically shut down after 25 sec.
Note: Panic mode can only be activated if the horn has been adequately configured by
your installer.
Quick Lockout
TM
(Also called secure panic.) For fast protection in emergency situations, the system will LOCK all
doors when you press the brake pedal while you hear the sound signal. (Quick lockout is only
available when panic mode has been set off.)
Cold Weather Mode
When cold weather mode is active, the engine starts every 2 hours and runs for 3 minutes (or for 8
or 20 minutes with diesel engines). Cold weather mode automatically ends after 24 hours.
To enter Cold Weather Mode:
Press and release the button and you will hear a beep, L-01 will appear on the display, then
press and hold the button for 3 seconds until the parking lights flash three times.
The remote control will beep once and the icon will appear on the display.
To exit Cold Weather Mode, do any one of the following actions:
Open the hood.
Start the engine by remote.
Turn the ignition key to the IGNITION ON (RUN) position.
Press and release the button and you will hear a beep. L-01 will appear on the display. Then
press the button for 3 seconds (the parking lights will flash once).
When the system exits cold weather mode, the remote control will beep once and the icon will
disappear.
To verify whether the system is in cold weather mode:
Press the brake pedal: If the vehicle is in cold weather mode, the parking lights will stay on while
the pedal is pressed.
How to access cold weather mode
Function Button pressed Icon Sound Instructions /description
To enter cold
weather mode
+
Beep
To exit cold weather
mode
+
None Beep
Press
and the press and
hold
for 3 seconds.