Autostart AS-2450vTW-FM Remote Starter User Manual


 
User Guide P. 19
Diagnostics – Parking Light Flash Table
Flashes Description
1
Doors locked, starter kill armed.
Run time has expired.
TRUNK button pressed.
Start signal received by the module.
Cold weather mode cancelled.
2
Doors unlocked, starter kill disarmed.
Remote start attempt cancelled by remote.
Exiting ignition valet.
Exiting remote valet.
Power-up reset.
Board set from manual to automatic; power
ON.
Power ON to OFF (automatic transmission).
2 slow flashes then
8 quick flashes
Reset from Manual to Automatic
3
Entering cold weather mode.
Extended run time.
Entering or exiting Ready Mode
Entering ignition valet.
Entering remote valet.
Disabling LED
4
+12 V detected on the brake input wire either while cranking or during run time.
Entering multi-speed tach programming.
Board set from automatic to manual; power ON.
Power ON to OFF (manual transmission).
5 Fast
Tach signal programmed.
6
A remote start was attempted while a tach-before-crank signal was detected before cranking.
8
Unit reset
10
A ground (-) signal was detected on the hood pin input wire.
When pressing
START/STOP
15 quick flashes…
The parking brake is connected to ground (automatic transmission).
1 – pause – 2
There was a remote start attempt while the vehicle was in valet mode.
Failed start: vehicle’s low battery voltage.
…followed by 1 flash Exiting cold weather mode ON SOLID for 3
seconds….
…followed by 3 flashes Entering cold weather mode
ON continuously
Idle mode: Idle mode is engaged
Run time: The vehicle has been remote started and is in run time.
ON 2 seconds
The hood has been opened and a ground (-) signal has been detected on the hood pin input
wire.
ON 4 seconds
Locking or unlocking a door (with Door pulses configured to 4 sec.)
ON 20 seconds
The hood pin has been flashed and you are now in the programming centre.
Continuous flashes
25 seconds
Panic mode is activated.
Continuous flashes
60 seconds
OEM alarm triggered (Honk)