Filter
Top Products
P.8 Installation Guide AS-1535 SH
9
(cont.)
PURPLE
(-) External
Trigger
Option 3 (Key Sense (-) Input): Connects to OEM Key Sense Wire.
When the Key is detected in the Ignition Switch (Ground (-) signal on the
OEM Key Sense Wire) the Starter Kill will not ARM even when it is set to
Passive Mode. If Secure Lock is programmed, LOCK and ARM will not be
activated while the Key Sense input is active (“active” meaning there is a
key in the Ignition barrel).
Option 4 (Smart Ignition Re-Lock): Connects to the Negative Door
trigger Input. When the Ignition Lock Option or the Lock Only Option is
enabled: after the Brake Pedal is pressed and after a Door has been
opened and closed, the Doors will RE-LOCK.
10
WHITE
(–) Ground
out when
running
This is a 500-mA constant ground output active when the vehicle is
running under a remote start. The output becomes active 1-second
before the Ignition and becomes inactive when the Module shuts down
(i.e.: runtime has expired or the
STOP button is pressed, etc.). The
output can be used to activate external relays, bypass kits, etc.
CAUTION! If multiple relays or modules are connected to the Ground
Out wire, ensure that they are all diode isolated in order to avoid
feedback and damaging the vehicle.
11
GREY
N/A
Leave this pin empty.
12
YELLOW
(+) Glow-
plug Light
input
This positive input will monitor the Glow Plug Light in Diesel Mode: it will
wait until the Glow Plug Light goes out to crank the Engine. Connect to
the side of the Glow Plug Light that is positive when the Light is on.
Note: In Diesel Mode there is a 15-sec. crank timing delay (or 25-sec. if
the run time is set to 30 min.): if the Glow Plug Light is still on after the
delay expires, the Module will proceed to start the Engine.
(Also known as the “wait-to-start light”.) The purpose of the Glow-plug
circuit on diesel vehicles is to pre-heat the Combustion Chamber before
the vehicle is started.
When a Remote Starter is installed on a diesel vehicle, the Glow- plug
section of the Ignition circuit must be activated and allowed to operate
before the vehicle is remote-started. For that purpose, the Glow-plug
input wire of the Module must be connected to the Glow-plug indicator
light of the vehicle. The Module will only accept positive Glow-plug input
signals, if the signal is negative, use a relay to invert its polarity.