Filter
Top Products
AS-1535 SH Installation Guide P.15
2. Test Hood Switch shutdown: with the vehicle running under the Remote Starter,
open the Hood; the vehicle should shut down. If it does not shut down, check the
Hood Pin-switch and its connector.
3. Test the Brake shutdown circuit: With the vehicle running under the Remote
Starter, press and release the Brake Pedal. The Engine should shut down
immediately. If the Engine continues to run, check the Brake Switch connection.
4. Door Locks, Auxiliary Outputs and Trunk Testing: Make sure each of these
options respond to the Transmitter (if they were installed).
5. Starter Kill option: Sit inside the vehicle with all the Doors closed. Arm the vehicle
and then try to start the vehicle with the key –it should not start. If the vehicle starts,
rewire the starter kill so it functions properly.
6. Valet Mode: Make sure the Module is able to enter and exit Valet Mode properly.
When setting the Module into Valet mode, the Starter Kill function is disabled, when
pressing
LOCK the Doors will lock but the Starter Kill will not be activated. (Refer to
User Guide for more information on Valet Mode)
7. Idle Mode: Make sure the vehicle properly goes into Idle Mode.
Closing Up
Use tie-wraps or screws to properly secure the Module and keep the wiring away from any
moving parts such as the Parking Brakes or Steering Column Shafts. Mount all switches in
good and accessible locations where they do not risk getting kicked or hit accidentally. Any
under hood wiring should be split loomed and tie strapped away from moving parts and heat
sources.
Always make all your connections before plugging in the Module. Keep in mind to plug the
fuses as the last step before the initial powering of the Module. Be sure to test all
functions properly before closing up the installation.
Make sure the Warning Label is applied on a visible place under the Hood.
Most comebacks are the result of misunderstandings about how a product works or performs.
Take the time to properly explain all functions and features to the customers before they
leave the premises. Doing this will save time and money.
Supplementary Information
Fifth Relay Output (2
nd
IGN or 2
nd
ACC or 2
nd
START)
This Remote Starter is equipped with a high-current programmable 5th relay onboard that
can be used to power a second Ignition, Accessory, or Start wire.
The Unit uses a series of jumpers; each set of jumper pins represents a function. In order to
activate any one of the three possible 2nd outputs, you must place the jumper (supplied) on
one of the three sets of pins and simply connect the 14 AWG wire to the second
IGN or ACC or
START
wire of the vehicle.