Filter
Top Products
AS-1535 SH Installation Guide P.7
7
WHITE /
ORANGE
(–) Starter
Kill output
The unit is equipped with a selectable passive- or active-arming
Starter Kill circuit that will immobilize the vehicle when the system is
armed. This wire will provide a constant 500-mA negative output when
the system is armed (locked by remote) or if remote started. This wire
should be connected to a Single Pole Double-Throw Relay (This wire
will connect to Pin 85, on the Relay, and Pin 86 will be connected to the
Ignition wire).
A second benefit of the Starter Kill is the Anti-Grind feature. When the
vehicle has been remote started the Anti-Grind prevents the starter
motor from re-engaging when the ignition key is inserted in the Ignition
switch and accidentally turned to the
CRANK position (The Starter Kill
output becomes active during remote starts).
8
ORANGE
(–) AUX 2
Output
Negative 500mA output. Can be programmed for one of the following
three options:
(1) Constant while the
LOCK and UNLOCK buttons are pressed + 1 sec
after release of the buttons.
(2)
LOCK + UNLOCK toggles ON / OFF. (Max.30 sec)
(3)
LOCK + UNLOCK toggles ON / OFF. (Max.60 sec)
(4) Priority Door Access (2
nd
UNLOCK press)
9
PURPLE
(-) External
Trigger
The External Trigger wire can be used for remote-starting the vehicle
with an external device. When the vehicle is running, triggering this
input will activate Idle Mode. The External Trigger wire can also be used
to operate as a negative trigger with the Trunk Pin-switch, the Key
Sense wire or the Door Pin-switch:
Option 1 Connects to Negative Trunk Pin. When this wire is
programmed for TRUNK PIN, pressing TRUNK will activate a 1-second
DISARM output. If ground (-) is detected on the TRUNK PIN (the Trunk has
been opened), an ARM pulse will be sent 5 seconds after the Trunk is
closes. An ARM pulse will be sent 4 seconds after the TRUNK button is
pressed if the Trunk pin state is unchanged (The Trunk was unopened).
DISARM is sent only if the system was previously locked and armed. If
Secure Lock is enabled, UNLOCK pulse(s) will be sent with DISARM, a
LOCK pulse and a REARM pulse will be sent when the Trunk is closed
or if the Trunk was left closed.
Option 2 (Default: Engine Start/Stop): The first Ground (-) pulse on
this input will start the Engine, the second Ground (-) pulse on this input
will stop the Engine.