Filter
Top Products
AS-1535 SH Installation Guide P.11
The Module has the ability to retain up to 4 different Transmitter codes; if a fifth Transmitter is
programmed, the code of the first Transmitter will be erased from memory. To erase all
Transmitter codes from memory, you must perform a Module reset (See “Resetting the
Module” on page 17 ).
To program the Transmitter on a second vehicle
(Multi-car Operation), you must press the TRUNK and
LOCK buttons (of the secondary Transmitter you wish to
program) during step 2 of Transmitter Programming.
How to Enter Options Programming Mode
The System is equipped with three custom Programming Modes, allowing the installer to
custom-fit the system according to the requirements of each vehicle. When getting into the
Option Programming Mode, the Parking Lights and the Siren will flash and chirp once, twice
or three times depending on the option you have entered. The unit will stay in Programming
Mode until the Hood Pin-switch or the Brake Pedal is pressed again. Therefore take your time
to make the proper selection. To return to the Programming Centre (Main Menu), press on
the Brake Pedal.
1. FLASH the Hood Pin Switch.
Before the 20 seconds have passed,
2. Press and hold the Brake Pedal, then press one of the following buttons on the
Transmitter:
x LOCK to enter Mode 1;
x UNLOCK to enter Mode 2; or
x TRUNK to enter Mode 3.
The Parking Lights and the Siren will flash and chirp once, twice or 3 times to confirm
entry into a Mode.
3. Release the Brake Pedal.
Table 2
The Module can only be programmed Function by Function. After selecting a Mode
(from 1 to 3), you will be taken to the first Function of that Mode. After entering an Option
number for Function 1, you will be automatically taken to Function 2, and so on; therefore, be
ready to re-enter all option numbers for all functions of the Mode you are accessing. You
may not skip Functions.
For each Function, select one of the four Options by pressing the corresponding
button on the Transmitter:
x LOCK for Option 1,
x UNLOCK for Option 2,
x TRUNK for Option 3, or
x START for Option 4.
Table 3
Once an Option has been selected the Parking Lights will flash 1, 2, 3 or 4 times depending
on the selected Option. At any time, you can press the Brake Pedal to return to the
Programming Centre (Programming Modes and Tach Programming).