Filter
Top Products
AS-1535 SH Installation Guide P.17
Turbo Mode
This Option allows turbochargers to idle down: after the user leaves the vehicle, the Engine will
keep running for 60 sec. and then shut down (It is a 1-minute Idle Mode).
Safe Start (Child Safety Mode)
(OFF by default.) Requires the user presses the START button on the Transmitter twice
within 3 seconds in order to start the vehicle.
If the Special Safe Start Mode is selected (SWAP Start):
x To start the vehicle, press the LOCK and UNLOCK buttons simultaneously.
x Pressing the START button triggers AUX2.
START button becomes AUX2 trigger and the AUX2 button becomes the START trigger.
Table 9
Vehicle Type – Gas Or Diesel
(Set to Gas Mode by default) In Diesel mode the system will wait for up to 18 seconds for
the Glow Plug Light to go out, before cranking the Engine. Note that the run time is
automatically extended when Diesel mode is selected.
Passive Or Active Arming
(Passive Mode by default.) The Starter Kill can be set to:
Option 1: PASSIVE Mode: The Starter Kill will arm automatically after 60 seconds.
Option 2: ACTIVE Mode: The Starter Kill will only arm once the user presses the LOCK
button.
Option 3: Passive Mode (3-minute timeout): The Starter Kill will arm automatically after 3
minutes.
Table 10
Resetting The Module
The system is equipped with a reset function that allows the installer to erase all Transmitter
codes and return all programmed Options to the factory default values.
To reset the Module:
1. FLASH the Hood pin switch.
2. Before the 20 seconds have passed, Press the Valet Button 6 times or more, until
the Parking Lights start to flash.
3. The Parking Lights will flash 8 times confirming the Reset.
Table 11
Events Logging
The Module will play back the last 4 Start Failure Events Codes via the Parking Lights and
L.E.D.
Events playback
Ensure that the Hood is up and that the Ignition is OFF.
x Hold down the Hood Pin-switch for 4 seconds.
x Release the Pin-switch.
x The Parking Lights will come on.