Filter
Top Products
AS-1535 SH Installation Guide P.3
Introduction
This Guidebook contains all information pertinent to the installation. Most (if not all) features
are grouped in the User Guidebook and therefore, should you need information on a feature,
you should refer to the User Guidebook
Included in the Package
Before beginning the installation, please review the Installation Guide – especially the Wiring
Diagram and the Options Programming.
It is very important that you familiarize yourself with the programming and operation of the
system, even if you have already installed an Autostart system in the past. There are many
great new features that may be overlooked if you do not read the manual; this would prevent
you from maximizing the potential of the Module.
Prior to the installation, make sure that all the hardware components required to install the
system are in the box.
The following is a list of components included in the kit:
x 1 – Control Unit
x 1 – Long-range super-heterodyne Receiver
x 1 – Plug-in push-button Valet switch (the Valet Button)
x 2 – Five-button multi-channel Transmitter
x 1 – Antenna interconnect cable
x 1 – Plug-in 2-volt LED
x 1 – 6-pin main Ignition Harness
x 1 – 5-pin Secondary Harness
x 1 – 2-pin Secondary Harness
x 1 – 12-pin Accessories Harness
x 1 – Hood Pin-switch
x 1 – Warning label
x User Guide Installation Guide
INDUSTRY CANADA USER NOTICE (Canada):
Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including interference that may
cause undesired operation of the device.
To reduce potential radio interference to other users, the antenna type and its gain should be
so chosen that the equivalent isotropically radiated power (EIRP) is not more than that
required for successful communication".
FCC USER NOTICE (U.S.A.):
The manufacturer is not responsible for any radio or TV interference caused by unauthorized
modifications to this equipment. Such modifications could void the user’s authority to operate
the equipment.
Before You Get
Started
…
Ƈ On vehicles with a manual Transmission,
always ensure that all Doors will get the Unit out
of Ready Mode. Switch the wire used so that it
is triggered by all Doors.
Ƈ Make sure that the Parking Brake and Door
Switch contacts work properly.
Ƈ When working on a vehicle, always leave a
window open.